CAMCO 38.4 Stereo Power Amplifier - 2 x 1900w at 4 ohm

CAMCO power Amplifier

1900 watts per channel Stereo

This is an incredible amplifer - lightweight 9.5Kg with enormous power.

This amplifier can deliver a genuine 1900w RMS into 4 ohms per channel. It's crystal clear sound is designed for massive headroom in your sound system.

Made in Germany and is the current model, see the Camco website at camcoaudio.com. Sold and supported in Australia these amplifiers have a RSP of $7,100

Manufacturers Specifications:

• Frequency Response 20 Hz - 20 kHz ± 0,15 dB
• Voltage Gain selectable: 26 dB, 32 dB, or 1,4 V input sensitivity
• Protection Circuits inrush-current limitation, temperature monitoring of transformer and heat-sinks, output DC protection, power transistor SOA protection, output over current protection, mains fuses protection
• Limiter switchable clip limiter
• Fan temperature dependent speed-controlled axial fan
• Ground Lift input ground lift switch on back panel
• Indicators LEDs for Mode, Signal, Clip, Output Current and faults for example like DC
• Input Connectors 3-pin XLR, male and female per channel, pin 2 = inphase (hot)
• Output Connectors one 4-pole SPEAKON connector for each output channel (bi-amping possible)
• Modes of Operation Stereo, Mono-Bridge and Parallel-Mono
• THD+N (typical) < 0,01 %
• 20 Hz - 10 kHz, 8 Ω load,1.0 dB below rated power
• Distortion SMPTE (typical) < 0,01 % 8 Ω load,1.0 dB below rated power
• Damping Factor > 400 8 Ω load, 1 kHz and below
• Dimensions (WxHxD) 483 x 88,9 x 330,7 mm (19”, 2U)
• Net Weight 9,4 kg
  

 This amplifier is used and in good condition.

Can be picked up in Waterloo 2017 or we freight at very reasonable rates.