Using the XS 800 gives your battery an optimum service life and operational reliability.
Equipment
The XS 800 is delivered with two different battery leads, one with clamps and one with eyelet terminals, all colour coded for easy +/- identification.
If the battery is difficult to access, the lead with eyelet terminals can be mounted to the battery, and the quick connectors are located so that it is easily reached for charging.
You can also purchase additional leads allowing you to have one lead with eyelet terminals fixed to all your vehicles with batteries that are difficult to get at, and charge them simply from the same charger.
Technical Data
| MODEL |
XS 800 |
| Input voltage AC |
170-260VAC, 50-60Hz |
| Output voltage |
Nominal: 12V |
| Efficiency |
85% |
| Charging voltage |
14.4V |
| Charging current |
0.8A max |
| Back current drain |
<1mA |
| Ripple |
10mV rms, 12mA (2%) |
| Ambient temperature |
-20°C to +50°C, output power is reduced automatically at higher temperatures. |
| Type of charger |
Four step, fully automatic switch mode with pulse maintenance. |
| Type of batteries |
12V lead-acid batteries (Wet, MF, AGM and GEL) |
| Battery capacity |
1.2-32Ah (1.2-100Ah maintenance charging) |
| Dimensions (L x W x H) |
142x51x36mm |
| Insulation |
IP 65 (splash and dust proof) |
| Weight |
0.3kg |
Batteries
The XS 800 charges lead-acid batteries (Wet, MF, GEL and AGM) from 1.2Ah to 32Ah. You will find an explanation of the various battery types under Charger University, Battery Types.
The charger can also be used for maintenance charging of 12V lead-acid batteries from 1.2Ah to 100Ah.
The XS 800 is easy to use. You do not need to make any settings. The charger adapts the charge to suit the battery and switches to pulse maintenance charging when the battery is fully charged.
| BULK CHARGE TIME |
| BATTERY SIZE (Ah) |
FOR ABOUT 80% CHARGE (h) |
| 2 |
2 |
| 8 |
8 |
| 20 |
20 |
| 60 |
60 |
| 100 |
>80 |
Safety
- Electronic safe, the charger will not damage vehicle electronics. The battery does not normally need to be disconnected from the vehicle when charging.
- Minimal gas build-up and a patent-pending spark protection system.
- Short circuit and reverse polarity protected.
- Double insulation.
- Splash and dust proof (IP65) and approved for outdoor use.
- Progressive temperature protection.
- Tested and approved by Intertec SEMKO AB. S-marked and conforms to the following standards: EN 60335-1, EN 60335-2-29, EN 55014-2, EN 55022, EN 61000-3-2 and EN 61000-3-3
Mounting