CYCLOPS 4DOOR 4CL-001 CENTRAL LOCKING KIT

THIS

4CL-001 CENTRAL LOCKING KIT

IS

NEW

IN SEALED BOX

EX-SHOP STOCK

RRP;$349

Introduction

• Electro-Mechanical activation
  Lock and unlock all doors by operation either front doors
• Electro-Mechanical activation
  This module uses negative lock and unlock signals from a remote alarms/immobilisers to mechanically operated the lock mechanism of a car door

Operation

• Master and slave actuators
  Each kit uses a master actuator for each front door, and a slave actuator for the rear door (4 in total). Master actuators control all actuators
• Full complement of hardware
  Supplied with all metal brackets, superior 3 point fixing clamps with slot / cross head screws, rods, worms, speed nuts and cabling required for standard installation
• Intelligent switch controller
  Includes active central locking controller

Wiring

• Pre-loomed wire harness
  Generous wire loom to connect four doors, all wires fully sheathed

Specifications

• Wide Operating voltage
  Operating voltage +9VDC to +15VDC
• Operating temperature
  -20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin
• Polarity protection
  The system circuitry is design to protect itself against accidental battery polarity reversal. This can happen when replacing the vehicle battery
• Short circuit protection
  The power supply wire to the system is protected against an internal fault within the system
• Current rating
  All relays rated to carry 15amps continuous, connector 8amps continuous

Compatibility

• Compatible with Cyclops remote control systems
  Cyclops range of immobilisers/alarms : P355, P375, P375B, P385, P755, P775, P775B, P785, KE-CLR-TX90, KE-CLR-TX11, S35i, S35B, S35C, S75i, S75B and S75C

Warranty

• Manufacturers warranty
  Guarantees product is free from manufacturing defects for 12 months from time of purchase

Standards Compliance

• Manufactured to international standards
  Produced in accordance with UNI-ES-ISO 9002

Legend:

   Will categorically need extra hardware and connections.
   May require additional hardware or connections.
   Additional relay and connection required in vehicles with boot solenoid. Relay and solenoid kit required for vehicle without solenoid.
   Vehicle circuit polarity may require addition components to convert voltage.
   Special order required - this is not part of the standard hardware.
   Special feature out of Dynamco's control.
   Conditions apply.
   Programmable option