
WLAN Indoor Singal Booster

Works with an indoor Wireless Access Point to improve its operation range and performance! The Signal Booster can increase the effective range and coverage area of the network.
Ideal for use with 2.4 GHz frequency hopping or direct sequence spread spectrum radio modems and 11 mbps IEEE802.11b devices. The booster increases range by providing transmit gain as well as low-noise receive gain. This receive gain increases the receive sensitivity of wireless LAN Access Point.
- Maximum output power of 1000mW by the Booster!
- Die Casting Aluminium for better heat exchange
- Signal activity LED
- High Gain, High Value, High Performance
- Low-noise receive gain
- Designed for 2.4GHz Wireless LANs
- Plug-and-play, Easy installation, no driver needed
- Brand NEW
- NOTE: Antenna and Access Point Router are NOT included
- Electricial Specification:
Operation Range: 2400-2500 MHz
Operation Mode: Bi-directional, half-duplex, Auto-Switching via carrier sensing
Frequency Response: ± 1dB over operation range
Input Power: 6dBm (Min.) , 20dBm (Max.)
Output Power: 1000mW/30dBm nominal for 802.11b/11Mbps
Connector: SMA Receptacle, 50 ohm
Transmit Gain: 17dBm nominal
Receiver Gain: 10dBm
Receive Noise Figure: 3.5dBm nominal - Mechanical Specification:
Operationg Temperature: 20 to 70 degree
Operating Humidity: Up to 95% relative humidity
Dimesnion: 7.8 cm (L) x 5.6 cm (W) x 2.9 cm (H)
Material: Die Casting Aluminum
Safety Certification: FCC/CE/VCC






