|
Weber carburettor full conversion kit
To fit: all MAZDA FE, F8, and F2 engines
This is an upgrade kit, will increase accelleration and torque.
The carb is fully reconditioned and fitted with electric idle solenoid. Caution: do not consider fitting other Webers without idle soleniod, as these were designed for engines pre-1980, and may cause run-on & engine damage. The fuel inlet and throttle is designed to fit to your original equipment.
If you are fitting this to an E2000 or Ford Econovan, Spectron van, we will supply the more compact air filter ( square one pictured) to fit under the cramped engine hatch. You will need to cut-out a small section of your inspection plate.
We sell 4 carburettors for the FE engine, this is the most popular with no choke.
Our kits are supplied with a high quality, heavy gauge stainless sports air filter. The fitting kit gives you everything you need to bolt it on and drive off: fuel line connectors, cable bracket, and manifold adaptor.
Please note: The manifold in pictures is for illustration only. The kit supplies all the hardware to fit the Weber to your manifold.
A must for those looking for easier service/greater reliability, and better accelleration!
This kit will fit: Mazda 626, 929, B2000, B2200, E1800, E2000- All with FE, F8, F2 engines.
Ford Telstar, Courier 2.2, Econovan, Spectron Van- All with FE, F8 engines.
Please state which car you have for correct installation components.
We have kits for all other engines. Please email or ph shop- BH 0754933788.
We supply a range of Weber & Holley conversion kits for a wide range of cars. Any questions for this kit or others, email or PH- BH0754933788. | 
Back to home page
) 
RECARB carburettors
Print
Report item
