|  |  |  |  |
You are Purchasing This BRAND NEW SEALED SERVGAS Hydropowered Aqua Powered 250NG HOTWATER HEATER
This is for internal installation and includes the Flue Section as well. There is no need for power or pilot to ignite. It runs on 8.4L/min, which means you never run out of hot water.
This is suitable for Site Caravan, Small holiday house, or unit, and very cheap to run.
RRP: $1045.00
Servgas Pty Ltd manufacture special hot water heaters for home units where it's difficult to install a standard type heaters.
The heaters are a standard balanced flued heaters, which draws it's air for burning and expells the products of combustion out through the same terminal.
| A HOT WATER SYSTEM WITH A DIFFERENCE |
|
The unique design of the SERVGAS AQUA POWERED HOTWATER HEATER allows the unit to be installed INSIDE a dwelling. Utilising a "balanced flue" system, the SERVGAS AQUA POWERED HOTWATER HEATER is installed either in a kitchen cupboard or a wall (external). The unit is sealed and draws no primary air from the room, rather, the balanced flue system not only draws its combustion air from outside but expells the burnt flue gases via the same means.
|
|
|
Ideal for the multi storey building where conventional flueing is not applicable i.e. apartments, flats, etc. with concrete floors and concrete ceilings. Conventional continous flow internal systems are top flued and cannot be installed in buildings where flue does not terminate to atmosphere.
The SERVGAS AQUA POWERED HOTWATER HEATER can be installed in high rise buildings as the entire installation is done from the inside. If gas hot water heating is your preference, and others just can't do the job, consider the SERVGAS AQUA POWERED HOTWATER HEATER, a unique design for a unique application. |
The Servgas Pty Ltd AQUA POWERED 250NG is an internal balanced flued instantaneous hot water heater designed for internal use only. The heat exchanger, burner, pilot assembly and over temperature switch is housed in a sheet metal cabinet finished in baked polyester white powder coated paint, these components is covered with a front panel which has a window to observe the pilot and main burner. The other components, Gas and Water valves,Hydro Generator, Ignition unit, vacuum chamber are all mounted on the bottom panel.On the Gas section front slide control is an adjustment for minimum to maximum gas rate, a ON & OFF switch and Green and Red LED`s to indicate working or failure, included with the unit is a pressure regulator for Natural Gas. And flexible gas and water pipes. All parts can be easily removed independently of each other with the use of commercially available Hand tools.
Capacity: 0.14 I/S at 30`C rise. Relief Pressure: 1000 Kpa. Maximum Water Working Pressure Mains pressure 800 kpa. Minimum Water Working PressureMains pressure 30 kpa.
Please visit http://www.servgas.com.au/pdf/Hydro_and_Range_Flyer.pdf for more information
PLEASE CONTACT ME TO QUOTE THE POSTAGE COST BEFORE YOU BID
*** PLEASE INSPECT ALL OUR TERMS AND CONDITIONS THOROUGHLY. IF YOU DO NOT AGREE WITH THEM, PLEASE DO NOT BID! ***
SERIOUS BIDDERS ONLY.
Thank you for looking
HAPPY BIDDING
PAYMENT INFORMATION
1.Bank transfer via Internet Banking is preferred method of payment
Please provide your EBAY USER ID in the bank description/ reference
2. Direct deposit in person at a bank requires emailing us the following:
- BSB Number of the bank location
- Date of deposit (dd/mm/yyyy)
- reference number
3.Bank cheque/ Money order/ Personal cheque
- Place your EBAY USER ID or ITEM NUMBER on the back of the money order or cheques.
- Allow an additional 3 business days for personal cheque to clear (Not recommended if item is urgent)
Failure to provide any of the required information above may result in delays to shippin.
TERMS & CONDITIONS
-
Before bidding please ensure you read all our conditions including our Return/ Refunds Policy and Warranty Policy.
-
Placing a bid on an item enters you into a legal contract. Do not bid if you do not intend to buy the item
-
Any questions please email before you bid.
Buyer is to contact me after auction end.
Payment must be received within three (3) days of auction end. You will need to notify us if you cannot pay within this period. Failure to do so will result in an UNPAID STRIKE against your account.
Manufacture Warranty is provided on all items.
Payment details will be sent via e-mail.
All care is taken in item listings however any misprints, omissions or mistakes are unintentional.
Please leave feedback once the item has arrived safely.
If there are any problems, please contact us, as our policy is "we aim to please."
If you buy but changed your mind you must pay a restocking fee of $50.00
There is no tax invoice produced for GST, only receipts for warranty purpose.
SHIPPING DETAILS:
-
Shipping is only within Australia
- Provide express post but can not use registered post or insurance at the same time.
- Please allow up to 5-7 working days for items to be delivery (from the day the item is despatched) In most cases, it will be much quicker.
-
Any charges incurred by parcels that cannot be posted due to Buyer providing incorrect address will be covered by the Buyer. These charges must be payed before item can be resent.
Powered by eBay Turbo Lister
|
| |
|