Vintage Teac AS-100 Stereo Integrated Amplifier- Rare

Superb and Rare Teac Amplifier from the 1970's for Auction.  Usual Tone control but for each Channel plus Loudness, Low and High Filters, and Full Mode Selection. A&B Speaker outputs.  Phono 1&2, Tuner, CD, Aux 1&2,  and Tape Monitor. LED Level Indicator. Main In/Pre Out. 3 AC Outputs of Rear Panel.  Recently Serviced. Good Cosmetic Condition accept for a few light scratches on top front edge. New Control knobs have been fitted as several of the originals went walkabout. I will supply the few that were left.  This is a fabulous sounding Amp. This unit is tested and operating well but Sold as in 'as is' condition. Returns considered on a case by case basis.

These are Vintage units...please do not expect it to look like or necessarily perform like it just left the showroom floor. Delivery East Coast is approximately 6 Business Days elsewhere is longer. If you buy you pay. I am not an inspection centre.

                                    SPECIFICATIONS:

 Type : All silicone transistor integrated amplifier(26 silicone transistors, 2 ICs ,2 thyristors, 9 diodes)
 Circuit: Differential quasi-complementary SEPP

POWER AMPLIFIER SECTION

Rated power:                    60w(both channel operate thd 0.2%, 8ohms load)
                                       40w/40w(each channel operate THD 0.2% 8ohms load)

Harmonic distortion           below 0.2% rated power
                                       below 0.1% 0.1w

Im distortion                     below 0.2% rated power

Power bandwidth:             10 - 40.000Hz    -3dB

Frequency response          5- 200.000Hz+0 ,-2dB at 1w

Signal to noise ratio           Better than 90dB

Residual system noise       Below 0.6mV

Input sensitivity                 1v for rated power

Input impedance                50.000 ohms

Output load impedance      4-16 ohms


PREAMPLIFIER SECTION

Inputs                             Phono-1,2: 2mV (input impedance 50.000 ohms)
                                      Tuner :150mV (input impedance 50.000 ohms)
                                      Aux-1,2 : 150mV(input impedance 50.000 ohms)
                                      Tape deck play:  150mV(input impedance 60.000 ohms)

Frequency response       10- 50.000Hz 1dB           
                        
Signal to noise ratio          Phono inputs: 70dB
                                       AUX inputs :80dB

---