Works with an indoor Wireless Access Point to improve its operation range and performance! The Signal Booster can increase the effective range and coverage area of the network.

Ideal for use with 2.4 GHz frequency hopping or direct sequence spread spectrum radio modems and 11 mbps IEEE802.11b devices. The booster increases range by providing transmit gain as well as low-noise receive gain. This receive gain increases the receive sensitivity of wireless LAN Access Point.

• Maximum output power of 1000mW by the Booster!
• Die Casting Aluminium for better heat exchange
• Signal activity LED
• High Gain, High Value, High Performance
• Low-noise receive gain
• Designed for 2.4GHz Wireless LANs
• Plug-and-play, Easy installation, no driver needed
• Brand NEW
• NOTE: Antenna and Access Point Router are NOT included

• Electricial Specification:
  Operation Range: 2400-2500 MHz
  Operation Mode: Bi-directional, half-duplex, Auto-Switching via carrier sensing
  Frequency Response: ± 1dB over operation range
  Input Power: 6dBm (Min.) , 20dBm (Max.)
  Output Power: 1000mW/30dBm nominal for 802.11b/11Mbps
  Connector: SMA Receptacle, 50 ohm
  Transmit Gain: 17dBm nominal
  Receiver Gain: 10dBm
  Receive Noise Figure: 3.5dBm nominal
• Mechanical Specification:
  Operationg Temperature: 20 to 70 degree
  Operating Humidity: Up to 95% relative humidity
  Dimesnion: 7.8 cm (L) x 5.6 cm (W) x 2.9 cm (H)
  Material: Die Casting Aluminum
  Safety Certification: FCC/CE/VCC